Custom Semi Finished Reed – Hardness Graded

Description

Semi-finished reeds are tip profiled to a near finished stage. Final personalized scraping and adjustments are left to you.

Your choice of cane, shape, and hardness level

Cane

Danzi, Donati, Gonzalez, Neuranter, Rieger, Rigotti

Hardness

Medium, Medium-Hard, Hard

Shape

Rieger 1A (Standard), Rieger 2 (Wide), Rieger 14 (Narrow)

Color

Colors will vary, and may be requested if available

Finishing Instructions

• Ream if necessary.
• Soak blank for 2-3 minutes.
• Clip the tip at 28mm from the 1st wire. Final blade length should be between 27 and 28mm from the first wire.
• If the tip is closed, gently squeeze the first wire from side to side with pliers. The opening of the blank should be about the width of a dime.
• If the wires are loose, tighten the first 2 wires so they are snug. Be careful not to over tighten.
• Clean/ remove excess cane from the collar of the reed with a razor blade or Exact-o knife.
• Carve the thumbnail and lightly file the sides.
• Lightly scrape or file the back of the reed if the reed is too hard or too bright (Hold the reed up to a light to look for dark spots)
• Allow the reed to sit for a couple days before testing and removing any more cane.
• Test the reed and make adjustments. Allow the reed to sit for a couple more days. Repeat as necessary.
• If the pitch is flat or the E and or C# in the staff are unstable, check if the wires are loose.
• If the wires are loose, tighten them. If the wires are snug, clip the tip in .5mm increments until the pitch is stable.